MX-5001N ADJUSTMENTS 5 – 32
ADJ 13 RSPF/DSPF parallelism
adjustment
13-A RSPF height adjustment
1) Make an RSPF height adjustment sheet
Cut copy paper in the longitudinal direction.
2) Perform the adjustment according to the flowchart below.
20mm
A4/Letter size
<Flow chart><Work procedure>
a) Check section A.
D
Yes
No
Adjust hinge D
until there is a
resistance in
section A.
(Counter-
clockwise)
*
Check to insure that a slight resistance is felt when pulling out
the RSPF height adjustment sheet.
Slowly pull out the RSPF height adjustment sheet.
Place the RSPF height adjustment sheet between section A
and the SPF glass height adjustment resin surface (a), and
close the RSPF unit.
b)
If it cannot be pulled out, turn the section D clockwise and
adjust in order to lift the RSPF unit.
If it can be pulled out without resistance, turn the section D
counterclockwise and adjust in order to move down the RSPF
unit.
Be careful not to cover the convex section of the glass
holding resin surface with the height adj
ustment sheet.
Start of the
adjustment
Check section A.
Is
there a resist-
ance?
The section
A is lowered
too much.
Turn the hinge
D to lift the
RSPF so that
there is a
resistance in
the section A.
(Clockwise)
a
A
To Next Page
Loading...
