1-67
BEFORE USING THE MACHINE
CLEANING THE BYPASS FEED ROLLER
If you find that paper fed from the bypass tray misfeeds or is soiled by the roller, clean the roller.
Before starting, remove the paper from the bypass tray.
1
Press the [POWER] key ( ) on the
operation panel to turn off the panel
power, and then switch the main power
switch to the off position.
2
Remove the roller cover from the bypass
tray.
Place your fingers behind the marks on the roller cover and
pull straight toward you. Pull alternately on the left and right
side of the roller cover.
3
To clean the rollers, wipe each roller
with a clean cloth.
Caution
When cleaning the rollers, be careful not to injure your hands.
Do not touch the surface of the roller if your hands are dirty.
If the dirt is difficult to remove, moisten the cloth with a small amount of water or neutral detergent, and then wipe with
a clean, dry cloth until no moisture remains.
4
Attach the roller cover on the bypass
tray.
Press the cover onto the bypass tray so that it locks into place.
Marks
To Next Page
Loading...
Need help?
General
