1-62
BEFORE USING THE MACHINE
REPLACING THE STAPLE CARTRIDGE IN
THE FINISHER
When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the procedure below
to replace the staple cartridge.
1
Open the cover.
2
While pressing the lever over to the left,
slide the finisher to the left until it stops.
Gently slide the finisher until it stops
3
Lower the staple case release lever and
remove the staple case.
Pull the staple case out to the right
4
Remove the empty staple cartridge from
the staple case.
Gently grasp the right side of the staple cartridge as shown and
lift to the left and up. The lock will release easily. After the lock
releases, continue lifting the staple cartridge to the left and up
to remove it.
• Even when a message appears in the operation panel, staples may occasionally remain in the staple cartridge.
• If staples remain, the lock will not release easily. Forcing the lock to release may deform the staple case and staple
cartridge, causing failure.
To Next Page
Loading...
Need help?
General
