MX-M260/M310/M260N/M310N SIMULATION 6 - 2
YES
YES
YES
NO
NO
YES
NO
NO
NO
YES
YES
YES
NO
NO
NO
NO
YES
YES
START (Normal mode)
Press the #/P key.
Press the asterisk (*) key.
Press the clear key.
Press the asterisk (*) key.
Standby for entry of
SIM code.
Standby for entry of
SIM sub code.
Enter the main code of
SIM with the 10-key.
Enter the sub code of
SIM with the 10-key.
The main code of SIM
is displayed.
Press the START key.
Press the START key.
Is there a sub code ?
Is there a item
selection?
Select the mode and the
item with the ↑ ↓ key
and the item key.
Operation check ?
Operating conditions
check ?
Data clear ?
Adjustments
or setting (counter data
change) ?
4
1
L1
3
2
L1
1
4
2
3
Press the START key.
Operation is made according
to the selected mode and item.
Operation is made according
to the selected mode and item.
Press the START key.
Press the START key.
Select "YES".
The selected mode and
the item are cleared.
The display is made according
to the selected mode and the item.
Do you
want to change the
content ?
Enter the new setting and
adjustment values.
Operation is made according
to the select ed mode and the it
(Other modes)
Press the START key.
The changed content
is stored.
NO
YES
Press the SYSTEM
SETTINGS key
Is it the same
simulation ?
Do you
want to end the
simulation ?
Press the SYSTEM
SETTINGS key
Do you want
to perform another
simulation ?
Press the clear all key.
The simulat
Returns to START
(Normal mode).
ion mode
is canceled.
If "Operation condition check"
refer to "Sensor display", this
process is not necessary.
∗
In the cause of SIM which is set by touch panel, the
changed content can be stored by the following key, touch.
·
[OK] key
·
Other item selection
·
↑ ↓ key
To Next Page
Loading...
Need help?
General
