Sharp PC-1600

PC-l600
8
Part No.
Component
Explanation
Step
2. Wind the wire around the pulley of the pulley
support rest (right) unit (2-6). After winding the wire
unit A (the longer one) around the pulley support
rest (left) unit (2-5) as shown in step l, wind it four (4)
times around the pulley gear unit (2-3). The position
of the second figure is shown be lox.
Wind the Wire
Four Times
Slit of the Pulley
Gear Unit
3. Passthe wire through the slit of the pulley gear unit
and wind it around the other pulley of the pulley
support rest (left) unit (2-5). Then, hook it onto the
left-side hook of the slider unit.
4. Test to confirm the condition of the wire unit by
checking whether the slider unit can be moved
smoothing front side to side by hand.
-78-