Sharp PC-1600

-
PC-l600
Step Part No.
Component
6
3-2
Idler gear
RE1.5 Retaining ring (E type)
3-7
Release lever
RE2
Retaining ring (E type)
3-8
Release lever spring
Explanation
Shift the double-gear (platen gear) of the roller unit
(3-3) with the coq, and set the idler gear (3-2). (Mark
the cog first.)
RE2
",
4-5 Slider unit Press the pulley support rest (right) unit (2-6) into
the frame (1-1).
7
2-7
Slider shaft
RE4 Retaining ring (E type)
2-6 Pulley support rest (rightl unit
2-4-1
Wire unit A
8
2-4-2
Wire unit B
2-4-3
Wire spring
1. Move the slider unit (4-5) to the right side of the
printer and hook the end of the wire unit B (the
shorter one) onto the hook of the slider unit.
(2-6)
\
-77-