Sharp UX-B700 - Page 21

UX-B700U
FO-B1600U
2 – 9
Digital line equalization setting (Reception) 7.2km 3.6km 1.8km 0km
1 No. 1 1 1 0 0 1
2 No. 2 1 0 1 0 1
Digital line equalization setting 7.2km 3.6km 1.8km 0km
3 (Transmission) No. 3 1 1 0 0 0
4 No. 4 1 0 1 0 0
Digital cable equalizer setting (Reception 0km 7.2km
5 for Caller ID) No. 5 0 1 0
6 No. 6 0 1 0
7 Error criterion 10 ~ 20 % 5 ~ 10 % 0
8 Anti junk fax check Yes No 1
1 Reserved 0
2 End Buzzer Yes No 1
3 Disconnect the line when DIS is received in No Yes 1
RX mode
4 Equalizer freeze control (MODEM) On Off 0
5 Equalizer freeze control 7200bps only No Yes 0
6 CNG transmission in manual TX mode Yes No 1
7 Reserved 0
8 Modem speed automatic fallback when RX Yes No 0
level is under -40dBm
1 Recall interval Binary input 0
2 No. = 8 4 2 1 1
3 1 2 3 4 0
4 EX 0 1 0 1 1
eg. Recall interval is set to 5 min.
5 Recall times Binary input 0
6 No. = 8 4 2 1 0
7 5 6 7 8 1
8 EX 0 0 1 1 1
eg. Recall times is set to 3 times.
1 Dialing pause (sec/pause) 4 sec 2 sec 0
2 Dial tone detection (before auto dial) No Yes 1
3 Reserved 0
4 Busy tone detection (after auto dial) No Yes 0
Waiting time after dialing 45 seconds 55 seconds 90 seconds 140 seconds
5 No.5 0 0 1 1 0
6 No.6 0 1 0 1 0
7 Reserved 0
8 Reserved 0
SW
NO.
DATA
NO.
ITEM
Switch setting and function
1
0
Remarks
Initial
setting
SW
l
B2
SW
l
B1
SW
l
A6
SW
l
A5
2 – 9