Sharp UX-B700 - Page 22

UX-B700U
FO-B1600U
2 – 10
1 Reserved 0
2 Reserved 0
3 Reserved 0
4 Reserved 0
5 Reserved 0
Auto dial mode delay timer of before line 0 second 1.5 seconds 3.0 seconds 4.5 seconds
6 connect No.6 0 0 1 1 0
7 No.7 0 1 0 1 0
8 Hold key Enable Disable 1
Auto dial mode delay timer of after line 1.7 seconds 3.0 seconds 3.6 seconds 4.0 seconds
1 connect No.1 0 0 1 1 0
2 No.2 0 1 0 1 0
3 Dial mode Tone Pulse 1 OPTION
4 Pulse → Tone change function by key Enable Disable 1
5 Dial pulse make/break ratio (%) 40/60 33/67 1
6 Reserved 0
7 Reserved 0
8 Recalling fixed only one time when dialing was Yes No 1
unsuccessful without detecting busy tone signal
1 DTMF signal transmission level (Low) Binary input 0
2 No. = 16 8 4 2 1 1
3 1 2 3 4 5 (n x 0.5dBm) 0
4 EX 0 1 0 0 0 0
5 eg. Signal transmission level is set to –4dBm. 0
6 Reserved 0
7 Reserved 0
8 Reserved 0
1 DTMF signal transmission level (High) Binary input 0
2 No. = 16 8 4 2 1 0
3 1 2 3 4 5 (n x 0.5dBm) 1
4 EX 0 0 1 0 1 0
5 eg. Signal transmission level is set to –2.5dBm. 1
6 Reserved 0
7 Reserved 0
8 Reserved 0
Reading slice (Binary) Factory Light Dark Darker in
setting dark
1 No. 1 0 1 0 1 0
2 No. 2 0 0 1 1 0
Reading slice (Half tone) Factory Light Dark Darker in
setting dark
3 No. 3 0 1 0 1 0
4 No. 4 0 0 1 1 0
5 Line density selection Fine Standard 0 OPTION
6 Reserved 0
7 MTF correction in half tone mode No Yes 0
8 Reserved 0
SW
NO.
DATA
NO.
ITEM
Switch setting and function
1
0
Remarks
Initial
setting
SW
l
B6
SW
l
C1
SW
l
B3
SW
l
B5
SW
l
B4
2 – 10