!!§I
Setting the Clock
When you use the VCR for the first time or after a power
failure of more than 60 minutes the clock will be reset.
Apply power to the unit to power on (see page 5,
item 3). Then perform the following procedure.
PREPARATION
*Select the video channel on your TV and turn on the
VCR. (See page 5, item 3.)
Initial Setting of Clock
r
0
First set the language (refer to page 10). Then press SET.
f
Changing the Clock Setting
1
@
Select whether the clock should show 12-hour AM/PM
time or
24-hour
time by pressing
A/V,
and then press
. .
Ex.:
12H
INorE>
l
“24H”
24.hour display.
l
“12H”
..,,,
12.hour AM/PM display.
l
12H
(AM/PM) mode is preset at the factory.
@ Set the present time with the numeric buttons or
A/v
on
the remote control. (First set the ‘hour’ digits and then the
‘minute’. If there is only one ‘hour’ or one ‘minute’ digit,
enter a 0 first.)
Set AM or PM, using AM/PM (12 hour) and then press
b.
Ex. : 10:28AM
INoTE
l If 12H mode was selected, then set the AM/PM indicator.
@ Set the date with the numeric buttons or
A/v
on the remote
control (First set the ‘day’ digits and then the ‘month’. If there
is only one ‘day’ or one ‘month’ digit, enter a 0 first.) and then
press
b.
Ex.: Dec. 15
(15/12)
@
Set the year digits with the numeric buttons or
A/v
on
the remote control. (Enter the last two digits of the year.)
Ex.: 99
@ Press SET.
@
Press MENU.
Select item “CLOCK” with
A/v
and press SET.
$&#,
Follow steps @ through @ above and step @
@
Press SET. To return to the normal screen, press MENU.
11
To Next Page
Loading...
