m
Auto Repeat
With this feature, the entire tape is played back repeatedly.
0
Set the REPEAT mode on the MODE-selection screen to ON.
When the video cassette reaches its end, the VCR will stop
BLUE BACK
playback, rewind the tape, and automatically play it back again.
AUTO RENTAL
JUST REC
pii5Tr)
l The ON/OFF status of the Auto Repeat can be checked on the MODE Selection screen. (See Mode Selection on page 15.)
(And when the Auto Repeat is ON, “REPEAT” will be displayed on the OSD.)
l If the Auto Repeat is on and the tape is rewound to the beginning with rewind or reverse
video
search, the tape will
automatically start playback.
m
Skip Search
!
When SKIP SEARCH on the remote control is pressed during playback mode,
SKIP
the VCR will perform a forward video search for a fixed interval of playback time
SEARCH
before resuming playback. Depending on how many times the button is pressed,
0
it is possible to set the forward video search time to approx. 30, 60, 90 or 120
seconds of recorded material.
I
Number of Times Pressed
Forward Video Search Time (On the VCR display)
1 time
2 times
3 times
Approx. 30 sec.
(of playback time)
Approx. 60 sec.
(of playback time)
Approx. 90 sec.
(of playback time)
4 times
Approx. 120 sec.
(of playback time)
During skip search, the interval of the video search will flash on the display
m
Intelligent Timer Recording (JUST REC)
When the tape is expected to run out halfway during timer recording (except for the Simple Recording Timer) in
the SP (standard play) mode, the mode will automatically change to the LP (long play) mode to prevent
termination of recording.
This function works only when JUST REC mode on the MODE selection screen is set to ON.
For example:
l When a
120-minute
programme is timer-recorded with a go-minute tape while the automatic select is set to LP
mode as shown below.
r
About 60 minutes
7
r
About 30
minutes7
SP (standard play) mode LP (long play) mode
Total: 120 minutes
I
l This function may not properly work for video tapes other than E-60, E-90, E-180 and E-240.
l This tape may not be completely used up.
l When more than one programme is set on the timer, the automatic recording function will work for the length of each timer-
set programme, but not for the total length of all programmes.
l When the LP mode is initially used for timer-recording a programme, if the tape is not long enough to record the entire length
of the programme, the programme will not be entirely recorded.
26
To Next Page
Loading...
