Sharp XV-Z2000 User Manual

-11
Introduction
Projector (Rear View)
Using the Kensington Lock
• This projector has a Kensington Security Standard connector for use with a Kensington MicroSaver Security
System. Refer to the information that came with the system for instructions on how to use it to secure the
projector.
Numbers in refer to the main pages in this operation manual where the topic is explained.
13
Remote control sensor
28
AC socket
Connect the supplied
Power cord.
11
Kensington Security
Standard connector
31
537
Rear adjustment feet
Intake vent
Exhaust vent
The speed and pitch of
the cooling fan may
change during operation
in response to internal
temperature changes.
This is normal operation
and does not indicate a
malfunction.
53
7
21
INPUT 2 terminal
Component signals.
Digital input type switch
22
INPUT 5/DIGITAL
terminal
21
22 23
23
25
26
25 26
INPUT 1 terminal
Component signals.
24
INPUT 4 terminal
Connect video
equipment.
24
INPUT 3 terminal
Connect video
equipment with an
S-video terminal.
27
RS-232C terminal
Control the projector using a
computer.
Terminals Refer to “INPUT Terminals and Connectable Main Equipment” on page 19.
XV-Z2000E_E_P06_15.p65 2004.10.20, 11:50 AM11

Sharp XV-Z2000 Specifications

General

Projection distance	2.6 - 3.9 m
Contrast ratio (typical)	2500:1
Screen size compatibility	40 - 200 \
Projector native resolution	SXGA (1280x1024)
Lamp type	SHP
Lamp power	275 W
Light source type	Lamp
Service life of light source	3000 h
Video in	XGA, Mac 19” (in intelligent compression), SVGA/VGA, Mac 16”/13”
I/O ports	2x component, 1x RCA video, 1x S-video, DVI-I (analogue component, digital & analogue RGB) x 1
Dimensions (WxDxH)	310 x 287 x 104 mm
Power requirements	100-240V AC, 50/60Hz
Power consumption (typical)	360 W
Market positioning	Home cinema

Weight and Dimensions

Weight	4300 g