Sharp XV-Z2000 User Manual

-48
Setting the Video System
The video input system mode is factory preset
to “Auto”; however, a clear picture from the con-
nected audio-visual equipment may not be re-
ceived, depending on the video signal difference.
In that case, switch the video signal.
Menu operation Page 40
Example: “Options” menu screen for
INPUT 4 mode
Description of Video Systems
Note
• The video signal can only be set in INPUT 3,
INPUT 4 mode.
•“Auto” cannot be set for PAL-M and PAL-N in-
put signals. Select “PAL-M” or “PAL-N” in “Video
System” menu for PAL-M and PAL-N input sig-
nals.
Signal Type Setting
This function allows you to select the input sig-
nal type RGB or Component for INPUT 5.
Menu operation Page 40
Example: “Options” menu screen for
INPUT 5 (RGB) mode
Description of Signal Type Settings
Description
Set when RGB signals are received.
Set when Component signals are
received.
Selectable items
RGB
Component
Note
• You can also select “Signal Type” using
on the remote control (only INPUT 5).
Using the “Options” Menu
Description
When connected to PAL video equip-
ment.
When connected to NTSC video
equipment.
When connected to SECAM video
equipment.
When reproducing NTSC signals in PAL
video equipment.
Selectable items
PA L
NTSC3.58
SECAM
NTSC4.43
XV-Z2000E_E_P47_52.p65 2004.10.20, 11:53 AM48

Sharp XV-Z2000 Specifications

General

Projection distance	2.6 - 3.9 m
Contrast ratio (typical)	2500:1
Screen size compatibility	40 - 200 \
Projector native resolution	SXGA (1280x1024)
Lamp type	SHP
Lamp power	275 W
Light source type	Lamp
Service life of light source	3000 h
Video in	XGA, Mac 19” (in intelligent compression), SVGA/VGA, Mac 16”/13”
I/O ports	2x component, 1x RCA video, 1x S-video, DVI-I (analogue component, digital & analogue RGB) x 1
Dimensions (WxDxH)	310 x 287 x 104 mm
Power requirements	100-240V AC, 50/60Hz
Power consumption (typical)	360 W
Market positioning	Home cinema

Weight and Dimensions

Weight	4300 g