Sharp XV-Z2000 User Manual

Introduction
-5
Accessories
Remote control
Two AA size batteries
Power cord
*
For Europe, except
U.K.
(1.8 m)
*Use the power cord that corresponds to the wall outlet in your country.
■ 3 RCA to 15-pin D-sub cable (3.0 m) AN-C3CP
■ DVI to 15-pin D-sub adaptor (20 cm) AN-A1DV
■ DVI cable (3.0 m) AN-C3DV
■ Lamp unit AN-K2LP
Note
• Some of the optional accessories may not be available depending on the region. Please check with your
nearest Sharp Authorised Projector Dealer or Service Centre.
(1)
(2)
(3)
Lens cap (attached)
Supplied accessories
Optional accessories
For U.K., Hong Kong
and Singapore
(1.8 m)
For Australia, New
Zealand and Oceania
(1.8 m)
Operation manual
21 pin RCA
conversion adaptor
(Supplied for Europe only)
Video cable
Marks Used in This Operation Manual
Info
........Indicates safeguards when using the projector.
Note
........Indicates additional information for setting up and operating the projector.
• In this operation manual, the illustration and the screen display are simplified for explanation, and may differ
slightly from actual display.
XV-Z2000E_E_P03_05.p65 2004.10.20, 11:50 AM5

Sharp XV-Z2000 Specifications

General

Projection distance	2.6 - 3.9 m
Contrast ratio (typical)	2500:1
Screen size compatibility	40 - 200 \
Projector native resolution	SXGA (1280x1024)
Lamp type	SHP
Lamp power	275 W
Light source type	Lamp
Service life of light source	3000 h
Video in	XGA, Mac 19” (in intelligent compression), SVGA/VGA, Mac 16”/13”
I/O ports	2x component, 1x RCA video, 1x S-video, DVI-I (analogue component, digital & analogue RGB) x 1
Dimensions (WxDxH)	310 x 287 x 104 mm
Power requirements	100-240V AC, 50/60Hz
Power consumption (typical)	360 W
Market positioning	Home cinema

Weight and Dimensions

Weight	4300 g