Sharp XV-Z2000 User Manual

-16
Setting Up the Projector
Position the projector perpendicular to the screen to achieve an optimal image.
Note
• The projector lens should be centred in the middle of the screen. If the horizontal line passing through the
lens centre is not perpendicular to the screen, the image will be distorted, making viewing difficult.
• For an optimal image, position the screen so that it is not in direct sunlight or room light. Light falling
directly on the screen washes out the colours, making viewing difficult. Close the curtains and dim the
lights when setting up the projector in a sunny or bright room.
Standard Setup (Front Projection)
■ Place the projector at the required distance from the screen according to the desired picture size. (See
page 17.)
Setting Up the Projector
Indication of the Projection Image Size and Projection Distance
See “Screen Size and Projection Distance” on page 17 for details.
Example : When using a wide screen (16:9)
200"
150"
100"
80"
60"
Projection
Distance
Centre
Picture Size
4.43m × 2.49m
3.32m
×
1.87m
2.21m × 1.25 m
1.77m
× 1.0 m
1.33m
×
0.75m
5.29m
–
7.95m
3.95m – 5.95m
2.62m
–
3.95m
2.08m
–
3.15m
1.55m
–
2.35m
XV-Z2000E_E_P16_18.p65 2004.10.20, 11:51 AM16

Sharp XV-Z2000 Specifications

General

Projection distance	2.6 - 3.9 m
Contrast ratio (typical)	2500:1
Screen size compatibility	40 - 200 \
Projector native resolution	SXGA (1280x1024)
Lamp type	SHP
Lamp power	275 W
Light source type	Lamp
Service life of light source	3000 h
Video in	XGA, Mac 19” (in intelligent compression), SVGA/VGA, Mac 16”/13”
I/O ports	2x component, 1x RCA video, 1x S-video, DVI-I (analogue component, digital & analogue RGB) x 1
Dimensions (WxDxH)	310 x 287 x 104 mm
Power requirements	100-240V AC, 50/60Hz
Power consumption (typical)	360 W
Market positioning	Home cinema

Weight and Dimensions

Weight	4300 g