39
8. Oil pan
Start tightening the bolts of the oil pan from the
center, then tighten the opposing bolt on opposite side
on the diagonal and specified torque.
Bolt tightening torque
10 – 12.7 N·m {1.0 – 1.3 kgf·m}
9. Oil level gauge · Gauge guide
Install the oil level gauge and gauge guide using 2
O-Rings.
10. Front plate
Install the front plate together with the gasket.
11. Cam shaft ass’y · Tachometer shaft · Plate
① Install the tachometer shaft.
② Install the cam shaft ass’y (taking care to the
bearing).
③ Fix the tachometer shaft and cam shaft ass’y with
the plate.
Plate tightening torque
9 – 13 N·m {0.9 – 1.3 kgf·m}
NOTE: Install the timing gear case taking care so
that the slider is not dislocated from the
guide pin.
067X
068X
To Next Page
Loading...
