Appendix E Maintenance and Inspection
Mobile DaRt Installation Manual
E-xx
E.8 Cleaning and disinfections
Cleaning and disinfections
How to Cleaning and disinfections
This equipment is not protected to permeation of a liquid.
Don't let a liquid permeate the inside of equipment in cleaning and
disinfections.
1. Check the equipment is turned off power.
Cleaning and disinfections work should work, after turning off
equipment power.
If equipment is turned on the power, there is a possibility of causing an
electric shock and a short circuit.
2. Cleaning and disinfections work are done.
Clean with the cloth into which alcohol or the antiseptic was infiltrated.
Do cleaning and disinfections work certainly also to what has unevenness in the
surface using a swab etc.
Do not splash antiseptic on this equipment. Do not spray of the
antiseptic on this equipment directly.
If an antiseptic goes into the inside of equipment, it will become failure
and the cause of the accident.
Do not use the following antiseptics.
When the following antiseptics are used, the performance and
safety of equipment cannot be guaranteed.
1. Chlorine type antiseptic
2. The antiseptic, which corrodes metal and plastic rubber, or paint
3. The antiseptic which unsuited metal and plastic rubber, or paint
4. A spray gas type antiseptic
5. A volatile antiseptic
6. An antiseptic with a possibility of entering the inside of a product.
CAUTION
CAUTION
CAUTION
CAUTION
To Next Page
Loading...
Need help?
General
