Shure Microflex MXCW - Accessing Web Applications via DNS and Views; Accessing Web Applications via DNS; Web Application Views Overview

Shure Incorporated
34/86
•
•
•
•
•
•
•
•
•
•
•
Using DNS to Open Web Application
You can bypass the Web Device Discovery application by entering the device DNS name into an internet browser. The DNS
name is derived from the model of the unit (MXCWAPT or MXCWNCS), in combination with the last three bytes (six digits) of
the MAC address, and ending in .local.
Format Example: If the MAC address of a unit is 00:0E:DD:AA:BB:CC, then the link is written as follows:
MXCWAPT: http://MXCWAPT-aabbcc.local
MXCWNCS: http://MXCWNCS-aabbcc.local
Web Application Views
The access point web application has dedicated views for specific meeting management tasks.
Open the web application and sign in to the desired view. To have access to all views, sign in as the administrator and select
one of the additional views from the user dropdown.
Admin View
This view is for meeting setup and configuration. Use this view to manage Devices, Audio, Meeting Controls, and Wireless
settings.
To access this view, do one of the following:
Sign in as Admin
Enter the IP address of the access point, followed by /admin
(example: http://192.168.11.137/admin).
Chairperson View
Use the Main tab for microphone control and managing speakers and speak requests during the meeting.
Use the Voting tab to select the voting configuration, view and share the last voting results, and remove certain participants
from a voting session.
To access this view, do one of the following:
Sign in as Chairperson
Select it from the administrator page
Enter the IP address of the access point, followed by /chairperson
(example: http://192.168.11.137/chairperson).
Display View
Display view shows the speaker list, request list, and voting results to meeting participants. Use this view to share a screen
with the entire meeting space.
To access this view, do one of the following:
Sign in to Display
Select it from the administrator or chairperson page
Enter the IP address of the access point, followed by /display
(example: http://192.168.11.137/display).
Tip: Put the page in full-screen mode during the meeting:
PC: F11