Shure Incorporated
45/86
1.
2.
◦
◦
◦
•
•
•
1.
2.
3.
4.
1.
2.
To set the number of speakers:
Go to Meeting Controls > Basic.
Use the plus sign (+) and minus sign (−) to change the number of speakers.
Total: Total number of active delegate and chairperson devices. This is the absolute maximum number of people
that can address the floor at the same time.
Delegate: Number of delegate microphones that can be open at the same time (excludes the chairperson).
Maximum Requests: Total number of participants that can be in the request queue. This is only available in Manu
al and FIFO mode.
Best Practices for Setting Active Speakers
Add an extra participant to the total number of speakers to allow a chairperson to speak at any time.
When using First In, First Out (FIFO) mode, set the maximum number of speakers to 1 so the participants must wait to
speak until another has finished.
Keep a microphone slot available for a remote caller.
Prevent Speak Button Conflicts
To prevent conflicts of a participant and an administrator or chairperson attempting to perform the same action on a unit:
Go to Meeting Controls > Advanced > Microphone off permissions.
Select Prevent doublepress of Speak button.
Set the amount of time (in seconds) for a conference unit to register a second press.
Optional: Allow a delegate to cancel the administrator or chairperson's speak button press by holding the speak button
down for an assigned duration between 1 - 120 seconds.
Changing Participant Microphone Off Permissions
To allow only the administrator or the chairperson to turn off participant microphones:
Go to Meeting Controls > Advanced > Microphone off permissions.
Select Only admin/chairperson can turn off participant microphones.
Audio Setup and Channel Routing
The MXCW system supports wireless, analog, and Dante network channels for a wide range of applications and installations.
Use the web application to customize the audio system for your meeting.
To Next Page
Loading...
