Sicam SBM V655 - 5 Fitting and Removing the Fl Ange; Removing Fl Ange; Fitting Fl Ange

656 234 2010-11-22| Sicam srl società unipersonale
Fitting and removing the fl ange | SBM V655 | 33 en
5. Fitting and removing the
flange
Fitting of the flange is necessary in the following situa-
tions:
 Commissioning
 When changing the type of flange
(universal - 3/4/5 hole)
 When changing the type of wheel
(passenger car - motorcycle)
! Balancing accuracy will be impaired if the flange has
not been properly fitted to the shaft.Before fitting the
flange, clean and degrease (remove corrosion protec-
tion) the cone of the shaft and the flange opening.
5.1 Removing flange
i
The SBM V655 must be switched on.
1. Press the pedal.
 This blocks the shaft.
2. Slacken off the hexagon socket head bolt.
651002-04 _Rf
3. Unfasten the flange by tapping with a rubber-headed
hammer on the cone end.
4. Pull the flange off the cone.
651002-06 _Rf
"Flange detached.
5.2 Fitting flange
i
Clean and degrease the cone of the shaft and the
flange opening.
1. Press the pedal.
 This blocks the shaft.
2. Slide the flange onto the shaft.
651002-05 _Rf
3. Tighten the hexagon socket head bolt.
651002-03 _Rf
"Flange fitted.