OPERATING INSTRUCTIONS | CFP CUBIC 8021989 / 2017-10-20 | SICK AG
Subject to change without notice
10
2 SAFETY INFORMATION
2.7 General safety notes
• Read the operating instructions prior to commissioning.
• These operating instructions are valid for devices from rmware version 2.00.
• The CFP Cubic is not a safety component under the EU Machinery Directive.
• Observe national safety and work safety regulations.
• Wiring work and the opening and closing of electrical connections may only be
carried out when the power is switched off.
• The radiated power is far lower than that from telecommunication equipment.
According to current scientic research, the operation of this device can be classi-
ed as safe and non-hazardous.
2.8 Repairs
Repair work on the sensor may only be performed by qualied and authorized personnel
from SICK AG. Interference with or modications to the sensor on the part of the cus-
tomer will invalidate any warranty claims against SICK AG.
To Next Page
Loading...
