SICK CFP CUBIC

OPERATING INSTRUCTIONS | CFP CUBIC8021989 / 2017-10-20 | SICK AG
Subject to change without notice
23
8OPERATION
• PNP = Switching output in PNP circuit
• NPN = Switching output in NPN circuit
• DRV = Switching output in push/pull function
Switching output behavior
Level
t
SP
RP
active
Error signal
disable
d
Switching output PNP NPN DRV Error status
Normally open/HNO
active U
v
0 V U
v
(PNP switched)
disabled
disabled 0 V
1)
U
v
2)
0 V (NPN switched)
1)
Pulldown only
2)
Pullup only
8.3.3 Normally closed with congurable hysteresis
Applications
− Overll protection
− Full signal
Conguration
Congure the Qx switching output as normally closed (using Q1 as an example).
Note:
The switching output designation (Q1 in the example here) changes according to the
selected process variable to be output.
1. Log in to Exprt mode, see “8.2.2 Exprt mode”.
2. Set the Output mode in the Q1-### / MODE1 / OUTPUT menu.
3. Congure the process variable to be output.
• Set the parameter to the required value in the Q1-### / PROC1 menu.
4. Set the Hysteresis mode in the Q1-### / OUT1 / HYST. menu.
5. Congure the switching output.
• Set the parameter to NC in the Q1-### / POL1 menu.