SICK GLS611 - Coordinate System

The configuration data of the device to be replaced that have been stored on the
computer can, e.g. in the event of a device failure, be downloaded to the replacement
device and permanently stored there. This enables a device to be quickly exchanged
with a replacement device of the same type.
7.3 Coordinate system
The X- and Y-coordinates provided by the device refer to the zero point of a coordinate
system in the field of view of the device. If the X- and Y-values are output in millimeters,
the zero point of the coordinate system is located in the center of the field of view.
–x
+x
+y
-y
0
Figure 23: Coordinate system in the field of view of the device
If individual 2D codes are used, the device determines the shift of the code center
point to the zero point of the coordinate system.
If multicode labels are used, the device determines the shift of the center point of the
multicode label to the zero point of the coordinate system.
7
COMMISSIONING
42
O P E R A T I N G I N S T R U C T I O N S | GLS611 8026021//2020-12-18 | SICK
Subject to change without notice