8 Maintenance
8.1 Maintenance plan
The product requires the following maintenance work at regular intervals:
Table 6: Maintenance schedule
Interval Maintenance work To be carried out
by
Cleaning interval depends on ambi‐
ent conditions and climate
Clean housing and front screen Specialist
Every 6 months Check the screw connections and
plug connections
Specialist
8.2 Cleaning the device
At regular intervals, check the inspection window and the housing of the device for
contamination (see "Maintenance plan", page 67). This is especially relevant in harsh
operating environments (dust, abrasion, dampness, fingerprints, etc.).
The inspection window must be kept clean and dry during operation.
NOTE
Exercise caution when cleaning the device. If the device position is changed during
cleaning, the work planes must be re-aligned.
NOTICE
Device damage due to improper cleaning!
Improper cleaning may result in damage to the device.
■
Only use suitable cleaning agents.
■
Never use sharp objects for cleaning.
Cleaning the inspection window
NOTICE
Damage to the inspection window!
Reduced analysis performance due to scratches or streaks on the inspection window!
►
Only clean the inspection window when wet.
►
Use a mild cleaning agent that does not contain powder additives. Do not use
aggressive cleaning agents, such as acetone, etc.
►
Avoid any movements that could cause scratches or abrasions on the inspection
window.
►
Only use cleaning agents suitable for the screen material (2 mm glass with
scratch-proof coating).
NOTE
Static charge may cause dust particles to stick to the inspection window. This effect
can be avoided by using an anti-static cleaning agent in combination with the SICK lens
cloth (can be obtained from www.sick.com).
MAINTENANCE 8
8020736/1K3Z/2023-06 | SICK O P E R A T I N G I N S T R U C T I O N S | PLOC2D 4.1
67
Subject to change without notice
To Next Page
Loading...
