NOTE
Length of connecting cables
•
To avoid significant attenuation in the UHF output power of the device due to the
cables, use short lengths of cable for the external antennas.
•
Details of the length-dependent losses in SICK cables can be found on the prod‐
uct page.
The call is made via the SICK Product ID: pid.sick.com/{P/N}/{S/N}
{P/N} corresponds to the part number of the product, see type label.
{S/N} corresponds to the serial number of the product, see type label (if indicated).
Enclosure rating
For further information, see "Conditions for specified enclosure rating", page 9.
NOTICE
Risk of damage to the product when the cover is open
When the cover is open, the device does not conform to a specified enclosure rating.
If necessary, only operate the device for a short time with an open cover for the
activities listed in the following: During this time, protect the device against moisture
and dust.
Temporarily open the side cover for the following tasks:
•
Inserting or removing the optional storage medium
•
Temporary use of the USB interface as a service interface
6.2 Wiring instructions
Pre-assembled cables:
NOTE
You will find recommended connecting cables and associated technical data on the
product page.
The call is made via the SICK Product ID: pid.sick.com/{P/N}/{S/N}
{P/N} corresponds to the part number of the product, see type label.
{S/N} corresponds to the serial number of the product, see type label (if indicated).
Pre-assembled cables with open cable end at one end:
NOTE
For information on the pin, signal and wire color assignments for the RFU630 device,
see "Signal assignment of cables with open cable end at one end", page 95 in the
appendix of these operating instructions.
NOTICE
Faults during operation and defects in the device or the system
Incorrect wiring may result in operational faults and defects.
■
Follow the wiring notes precisely.
6 ELECTRICAL INSTALLATION
40
O P E R A T I N G I N S T R U C T I O N S | RFU63x 8027750//2022-12-15 | SICK
Subject to change without notice
To Next Page
Loading...
