SICK RFU63 Series - Overview of the Commissioning Steps

Connection module Number of connectable devices Fuse rating
CDB650-204 1 1 x 2A
CDM420-0006 1 1 x 2A
CDM420-0007 2 2 x 2A
The fuse is located in the “secondary” circuit after the switch S1.
NOTE
Connection diagrams for the connection modules
The connection diagrams can be found in the appendix of these operating instruc‐
tions.
•
see "Connection diagrams of connection module CDB650-204", page 99
•
see "Connection diagrams of connection module CDM420-0006", page 112
NOTE
Connection modules
Detailed information on mounting and electrical installation can be found in the operat‐
ing instructions for the respective connection module.
You can find the operating instructions on the product page.
The call is made via the SICK Product ID: pid.sick.com/{P/N}/{S/N}
{P/N} corresponds to the part number of the product, see type label.
{S/N} corresponds to the serial number of the product, see type label (if indicated).
NOTE
Wiring the signals without a SICK connection module
►
When using a customer-supplied connection unit, refer to the relevant connection
diagrams and descriptions for the basic methods for wiring the signals.
•
see "Connecting the supply voltage", page 49
•
see "Wiring data interfaces", page 53
•
see "Wiring the CAN interface", page 55
•
see "Wiring digital inputs ", page 55
•
see "Wiring digital outputs ", page 57
•
An alternative adapter cable for free wiring with female connector, M12, 17-pin,
A-coded and open end is available.
NOTE
You can find adapter cables on the product page.
The call is made via the SICK Product ID: pid.sick.com/{P/N}/{S/N}
{P/N} corresponds to the part number of the product, see type label.
{S/N} corresponds to the serial number of the product, see type label (if indicated).
7.2 Overview of the Commissioning Steps
The device is configured using a configuration tool. During initial commissioning, this is
normally done use the SOPAS ET configuration software.
Other configuration tools are also available, for example a web server or command
strings, depending on the task. For more information, see "Operating options and
configuration tools", page 76.
7 COMMISSIONING
64
O P E R A T I N G I N S T R U C T I O N S | RFU63x 8027750//2022-12-15 | SICK
Subject to change without notice