82
Appendix
Gigaset WLAN Repeater 108 / englisch / A31008-M1030-B101-3x-7619 / appendix.fm / 06.11.2008
Template 2005_05_02
Appendix
This appendix contains information about:
u Basic settings for wireless connection of two games consoles (see below)
u Configuring the network (see page 84)
u Updating IP addresses (see page 109)
u Troubleshooting (see page 113)
u Specifications (see page 118)
u Approval (see page 119)
u Customer Care (see page 121)
Settings for wireless connection for games consoles
and set-top boxes
The following example describes what settings you need to make if you want to wire-
lessly connect two games consoles using two Gigaset WLAN Repeater 108 devices.
The configuration description always refers to the factory settings of the
Gigaset WLAN Repeater 108.
Configuring the first Gigaset WLAN Repeater 108 (as an access point)
ì Start up the user interface of the Gigaset WLAN Repeater 108 from the PC
(see page 18) and select Basic Setup Wizard.
ì Select Access point as Operating Mode.
ì On the wireless network settings screen, select the Channel and enter the required
SSID.
In Super G mode (see page 56), however, the channel is set automatically.
ì On the local network settings screen, select the following options:
– IP address type: Static
– DHCP Server: On
ì On the Security Setup Wizard close-down screen, deactivate the option to start the
Basic Setup Wizard and click Finish.
To Next Page
Loading...
