Siemens 2000

Description of functions Alphabetical Reference
69
LAN Port Settings
• Here you must define the bandwidth at which the optiPoint 410/420
should be run. The required value depends on the bandwidth that the
switch or router supports in the network.
• A restart is necessary after the change.
Æ page 23 Æ page 52
Language
• Configurable on optiPoint 410/420 standard/advance only.
• Select the language that should be used for local applications here.
• Available languages: English, German, French, Italian, Spanish, Portug-
ese, Dutch.
•Standard value Æ page 96.
Æ page 48
LDAP Server IP Address
• Only configurable on optiPoint 410/420 standard/advance and only re-
quired if a display module or application module will be used.
•If an Æ LDAP server is being used, enter the Æ IP address of this serv-
er here.
Æ page 47
LDAP server Port
• Only configurable on optiPoint 410/420 standard/advance and only re-
quired if a display module or application module will be used.
•If an Æ LDAP server is being used, enter the Æ Port number here for
communication with this server.
• Valid values: 1 ... 65535.
Æ page 47 and Æ page 56
Bandwith Possible application
Auto in standard case
10/Full in 100 Mbit networks in full duplex
[[1]]
process
[1] Up to a date, the data can be simultaneously transmitted and received.
10/Half in 10 Mbit networks with half duplex
[[2]]
process
[2] Up to a date, the data can only be transmitted or received.
100/Full in 100 Mbit networks in full duplex
[1]
process
100/Half in 10 Mbit networks with half duplex
[2]
process