Installing, exchanging and connecting modules
7
102 | 248
Mounting in the power supply
Figure 49: Installation of the 150 W power supply in the Comfort housing
1 DIN rail for power supply
2 Fixing screws for DIN rail
3 Power supply (150 W) FP2004-A1
4 Bottom fixing screw
5 Retaining bracket
6 Slot for retaining bracket
X1 Mains connection terminal
X8 Supply output terminal
X11 Monitoring signals terminal
1. Slide the retaining bracket (5) into the mounting slot (6) from below as shown.
The bracket jams solidly.
2. Attach the power supply (3) to the DIN rail (1) as shown using the affixed DIN
rail clip. To do this, hook the power supply on at the top and then press it down.
3. Screw the power supply (3) to the retaining bracket (5) with fixing screw (4)
from below.
4. Connect the power supply according to the pin assignment.
1
2
X8
456
To Next Page
Loading...
