Installing, exchanging and connecting modules
Ethernet switch FN2008 and safety module FN2009
7
144 | 248
7.14.2 Installing the modules
The process of installation using the mounting kit is identical for all housing
variants and applies to the following modules:
● Ethernet switch (MM) FN2008-A1
● Security module (firewall) FN2009-A1
Figure 77: Example: Installation in the Standard empty housing
1 Bottom DIN rail (for optional second module)
2 Angle plate
3 Top DIN rail with retaining bracket for FN2008-A1 or FN2009-A1
4 FN2008-A1 or FN2009-A1
1. Attach the module's top snap-in guide (4) onto the top DIN rail (3) at an angle
from above and gently press down until it snaps into place.
2. If necessary, install a second module on the lower DIN rail (1).
– Install a retaining bracket for a second module.
3. Wire the module as described below.
3
2
1
4
To Next Page
Loading...
