Siemens FS720 - Rear Panel in Standard Housing

Overview
St
ation rear panels (packaging unit)
3
18 | 248
Building Technologies
A6V10210390_m_en_
--
Fire Safety
2018
-
08
-
29
3.2.2 Rear panel in Standard housing
The setup of the different fire control panels in the Standard housing is always
identical.
Figure 2: Fire control panel in Standard rear panel
1 Standard rear panel
2 Hole for wall mounting (top)
3 Fastening tabs for the cover cap
4 Openings for cable feed from rear side
5 Recesses for the hinges of the operating unit
6 Mounting holes for operating unit
7 Periphery board (2-loop)
8 Holes for wall mounting (bottom)
9 Secondary-side cabling of the power supply
10 Primary-side cabling of the power supply
11 Power supply
12 DIN rail with network separation terminals, also for additional components
13 Strain relief for mains supply cable
2
5
6
7
1
3
4
13
12
6
11
6
5
6
8
10
9
8
9