Siemens FS720 - Module Bus Cards; Installation

Installing, exchanging and connecting modules
Module bus cards
7
175 |
248
Building Technologies
A6V10210390_m_en_
--
Fire Safety
2018
-
08
-
29
7.17.3.2 X9 supply
Pin Designation Description
1 VSYS+ System supply (DC 24 V)
2 VSYS+ System supply (DC 24 V)
3 VSYS+ System supply (DC 24 V)
4 VSYS- System supply (0 V)
5 VSYS- System supply (0 V)
6 VSYS- System supply (0 V)
Admissible cable cross-section: 0.5…2.5 mm²
7.17.3.3 X11…X52 connection terminals for the module bus card
The module bus card determines the PIN assignment of the four connectors. You
will find the pin assignments in the description of the corresponding module card.
The assignment of the connector is:
● Connections of module bus card 1 are on connectors X11 and X12
● Connections of module bus card 2 are on connectors X21 and X22
● Connections of module bus card 3 are on connectors X31 and X32
● Connections of module bus card 4 are on connectors X41 and X42
● Connections of module bus card 5 are on connectors X51 and X52
7.18 Module bus cards
7.18.1 Installation
The module bus cards are installed in the card cages of fire control panels FC723
and FC726. The following module bus cards are available:
● Line card (FDnet/C-NET) FCL2001-A1
● Line card (SynoLOOP) FCL7201-Z3
● I/O card (programmable) FCI2008-A1
● I/O card (horn, monitored) FCI2009-A1
● I/O card (RT) FCI2007-A1
The module bus cards are installed in the same way in all card cages and slots.
4
3
6
5
X9
2
1
VSYS+
VSYS+
VSYS+
VSYS-
VSYS-
VSYS-