Installing, exchanging and connecting modules
7
222 | 248
7.32 Remote EVAC-NL and EVAC-NL mimic display
driver
7.32.1 Remote 20-zone EVAC-NL indicator
Figure 133: Example of remote mounting of the 20-zone EVAC-NL indicator in an Eco housing
1 EVAC-NL connector board FTI2002-N1
2 Eco housing (example)
3 Power supply (70 W) (example)
4 EVAC-NL connector board FTI2002-N1
5 Operating add-on FCM7221-H3
6 EVAC-NL operating unit FTO2007-N1
7 EVAC-NL operating unit FTO2007-N1
Preparation
The 20-zone EVAC-NL indicator is available as a component in the operating add-
on FCM7221-H3. It can be installed in a station as an operating add-on or remotely
operated in any housing. In this instance it is also supplied using any separate
power supply, which can be installed in the housing, or via an external power
supply.
The following components are also needed to operate the remote operating add-on
FCM7221-H3:
● Any housing or Eco housing FH7201-Z3
● Any DC 24 V power supply or power supply (70 W) FP2015-A1
● 1 or 2 EVAC-NL connector boards FTI2002-N1 (1 each per 10 zones)
● 34 pin x 1 mm ribbon cable for connecting to the EVAC-NL connector board
FTI2002-N1
● RS485 module FCA2001-A1 for installation in the associated control panel
X1
X1
X402
1 2
1 2
1 2
1 2
1
33 34
33 34 33 34
33 34
1 2
1 2
1 2
1 2
1
33 34
33 34 33 34
33 34
X1
X1
X5
X4
X3
X2
X5
X4
X3
X2
X1
X2
2
3
4
1
To Next Page
Loading...
