Installing, exchanging and connecting modules
7
113 |
Building Technologies
● The connection lines marked in bold of the additional cable tree (3) and the
existing cable tree (2) must be wired again when installing the second power
supply (slave).
● In order to avoid operating temperature differences, the two power supply units
must be mounted next to each other in the same housing.
● The batteries and the system supply must only be connected to the master
power supply unit.
● Only one temperature sensor must be connected to the master power supply
unit.
● The temperature sensor must be fitted close to the batteries. (You will find
precise details in document A6V10210390).
NOTICE
Damage to the power supply
Different versions (A4/A5) of the power supply (150 W) may not be switched in
parallel.
To Next Page
Loading...
