Installing, exchanging and connecting modules
7
121 |
Building Technologies
1. Screw the spacers (2) into the threaded hole on the rear panel (1) to the right of
the periphery board.
2. Screw the two spacer bolts (9) into the threaded holes (10) on rear panel to the
left of the periphery board.
3. Screw one counternut (8) onto each spacer bolt (9).
4. Screw the fork heads (7) onto the spacer bolts (9) and fix them in a horizontal
position (in accordance with the figure) using the counternut (8).
5. Insert the mounting plate (4) with the hinge brackets (6) into the fork heads (7)
so that the fastening clamps (11) can be inserted into the fork heads from
above as shown.
6. Swivel the fastening clamps (11) backwards so that they snap in place in the
spacer bolts (9) (see [13] in figure).
7. Swivel the mounting plate (4) over the periphery board and fix it in the spacer
bolts (2) with the fixing screws (3, 5).
8. If the mounting plate is not true, the fork heads can be adjusted with the
counternuts (8) (loosen the fastening clamps and remove the mounting plate).
To Next Page
Loading...
