ing, exchanging and connecting modules
Installing an Ethernet switch (modular) FN2012
7
159 |
Building Technologies
Figure 87: Large mounting bracket installed without supply
Figure 88: Supply installed on top of large mounting bracket
1 Housing (Large)
2 Large mounting bracket
3 U-rail installed
4 Retaining bracket installed
5 3x fixing screws for mounting bracket
6 3x holes for fixing screws
7 3x threaded holes in rear panel
8 Mounting flange for the power supply (150 W)
9 U-rail for the power supply (150 W)
10 Power supply (150 W)
w Power supply (150 W) is removed
1. Mount the mounting bracket (2) in the Large housing (1) as shown and screw
the screws (5) into the threaded holes (7) in the rear panel.
a The power supply U-rail (9) is located in the recess of the mounting
bracket.
To Next Page
Loading...
