Siemens FS720 - Page 170

Install
ing, exchanging and connecting modules
Card cage
7
170 | 248
Building Technologies
A6V10210390_m_en_
--
Fire Safety
2018
-
08
-
29
Installation of card cage (5 slots) FCA2008-A1 in FC726
Figure 98: Installation of card cage (5 slots)
1 Rear panel (FC723) or mounting plate (FC726)
2 Periphery board
3 Card cage housing cover (EMC protection)
4 Card cage
5 Mounting holes for screws (2) in card cage housing
6 Mounting holes for screws (4 pieces) in printed circuit board
1. Tighten the 4 fixing screws of the printed circuit board (6) as follows:
– For the FC723 on the rear panel (1, top figure)
– For the FC726 on the mounting plate (1, bottom figure)
2. Tighten the 2 fixing screws in the card cage housing (5) as follows:
– For the FC723 on the rear panel (1, top figure)
– For the FC726 on the mounting plate (1, bottom figure)
3. Insert the desired module bus cards in the card cage (see chapter 'Module bus
cards').
4. Mount the housing cover (3) of card cage and secure with the four screws.
5. Connect the card cage according to the following pin assignment.
1
2
3
456