Installing, exchanging and connecting modules
7
216 | 248
Figure 128: Using the license key on the operating unit with PMI & mainboard FCM2027
Figure 129: Using the license key on the operating unit with PMI & mainboard FCM2004
1 Holder for the license key
2 License keys
Disconnect the station from the power supply
If the station is not disconnected from the power supply or if the license key is
inserted when the station is switched on, the license key functions will not be
enabled.
You will find a detailed description of how to disconnect the station from the
power supply in document A6V10210416.
License key installation position: The wider side points toward the clamp, the
narrower side toward the printed circuit board.
w The station is current-free, i.e., it has been disconnected from the power supply
and the batteries have been disconnected too.
l Raise the clamp of the retainer (1) and push the license key (2) underneath the
clamp.
a After a restart, the new functions will be enabled.
To Next Page
Loading...
