Mounting and installing extinguishing control panels
6
49 |
Building Technologies
Figure 24: Installing the card cage in the control panel for 1-sector extinguishing
1 Housing (Comfort)
2 3x screw bushings on the rear panel for mounting panel
3 Mounting panel for cables
4 3x screws M3 for cable carrier
5 Card cage (1 sector exting.) FCA2046
6 7x screws M3 for card cage (1 sector exting.)
7 7x screw bushings on rear panel for card cage (1 sector exting.)
1. Position the card cage FCA2046 (5) on the rear panel (Comfort) (1) as shown.
2. Fasten the card cage (5) in the screw bushings (7) with 7 screws (6).
3. Position the mounting panel (3) on the rear panel (Comfort) (1) as shown.
4. Fasten the mounting panel (3) in the screw bushings (2) with 3 screws (4).
5. Wire the card cage in accordance with the wiring diagram and fasten the
connection cables to the mounting panel (3) with cable ties.
1
2
3
4
5
6
To Next Page
Loading...
