Siemens HiPath 3000 Opearting Instructions

Step by Step
Making and Answering Calls
12
Making and Answering Calls
Special default ring signaling is set for your telephone:
• When you receive an internal call, your telephone
rings once every four seconds (single-tone se-
quence).
• When you receive an external call, your telephone
rings twice in rapid succession every four seconds
(dual-tone sequence).
• When you receive a call from the entrance tele-
phone, your telephone rings three times in rapid
succession every four seconds (triple-tone se-
quence).
• If a call is waiting, you hear a short tone (beep) every
six seconds.
The number or the name of the caller appears on the
display.
Answering a Call With the Handset
The telephone rings. The caller appears on the screen.
C
Lift the handset.
J
or
K
Raise or lower the volume. Keep pressing the key until
the desired volume is set.
Ending the call:
I
Replace the handset.
or
Press the key.
Answering a Call with the Speaker
(Speakerphone Mode)
The telephone rings. The caller appears on the screen.
Press the key. The LED lights up.
Speakerphone mode.
J
or
K
Raise or lower the volume. Keep pressing the key until
the desired volume is set.
Release
This function is not available with
optiPoint 400 economy.
Speaker

Siemens HiPath 3000 Specifications

General

Brand	Siemens
Model	HiPath 3000
Category	Telephone
Language	English