Siemens HiPath 3000 - Testing the Telephone; Testing the Telephone Functions; Checking the Key Assignment

Step by Step
Testing the Telephone
60
Testing the Telephone
Testing the Telephone Functions
You can test your telephone functions.
Precondition: Your telephone is idle.
Press the key. The LED lights up.
Select and confirm.
or
FB=9
Enter the code.
If everything is OK,
• all LEDs on the telephone start flashing, including
the ones on the key module (only the Program/Ser-
vice menu LED lights up);
• your station number appears on the screen;
• all pixels in the display are activated;
• the ringer signal sounds.
Checking the Key Assignment
You can check the assignment of keys on your tele-
phone to see which functions are programmed on
which keys.
Press the key. The LED lights up.
Select and confirm.
or
FB: Enter the code.
Press the key. The key assignment appears on the
screen.
Select and confirm.
or
Select and confirm.
Program/Service
*
940=Phone test?
Program/Service
*
91=Prog. feature key?
US: Another key?
UK: Program another key?
US: Exit?
UK: End?