Why does my Siemens HiPath 4000 Telephone say 'Connect. No dial tone available'?
If your Siemens Telephone displays 'Connect. No dial tone available' immediately after pressing the Talk key, it means calls cannot be made because the communication system is currently in use by other users. Please try your call again later.
What to do if my Siemens HiPath 4000 shows 'Time exceeded'?
If your Siemens Telephone displays 'Time exceeded', it means the maximum input time was exceeded because the On-hook key was not pressed, and there were long pauses between keystrokes. To resolve this, avoid long pauses when entering information and press the On-hook key.
What to do if my Siemens HiPath 4000 says 'Re-enter code:'?
If your Siemens Telephone displays 'Re-enter code:', it means the communication system is overloaded. Please wait and try again later.
What does it mean if my Siemens HiPath 4000 Telephone says 'Not available'?
If your Siemens Telephone displays 'Not available', it indicates that the function you are trying to use is currently unavailable. Wait and try again later, or ensure you have entered the phone number correctly. You may also need to call the attendant console.
What to do if my Siemens Telephone shows 'Feature not avail.'?
If your Siemens Telephone displays 'Feature not avail.', 'Incorrect entry', or 'Key not programmed', it indicates that a speed dial number is not available, an appointment was entered incorrectly, the entry is blocked or not allowed, a prerequisite has not been fulfilled, or the number dialed was incomplete. Correct your input, select a permitted option, or enter the phone number in full.
How to fix 'Base n lashes' error on Siemens HiPath 4000 Telephone?
If your Siemens Telephone displays the line "Base n" lashes, it could be due to several reasons: * The handset is not registered - register the handset. * The handset is outside the base radio range or the radio signals are too weak - move closer to the base or change your position. * The intervals between synchronization attempts are too long - switch the handset off and then back on again.
Why does my Siemens Telephone say 'no access'?
If your Siemens Telephone displays 'no access', it means a blocked function was called. You must apply to the relevant service personnel for the COS for the blocked function.
How to fix a Siemens Handsets with no display?
If your Siemens Handsets has no display, it could be due to a couple of reasons. The mobile telephone might not be switched on; in this case, press the on-hook key until you hear a confirmation tone. Alternatively, the battery might be empty; in this case, charge or replace the battery and try again.
Why does my Siemens Telephone say 'not available' after dialing?
If your Siemens Telephone displays 'not available' after dialing, it means the phone number was not fully entered, or the star or hash key was not pressed. Ensure you enter the phone number correctly or as prescribed.
Why does my Siemens HiPath 4000 say 'protected'?
If your Siemens Telephone displays 'protected', it indicates that data transfer is active. Wait and try again later.
General| Architecture | Modular |
|---|---|
| Supported protocols | SIP, H.323, ISDN |
| VoIP Support | Yes |
| ISDN Support | Yes |
| Analog Support | Yes |
| Integration | CTI, CRM, ERP |
| Compatibility | Siemens |
To Next Page