Safe use of the device
2
Unless otherwise stated all safety-related information in this document applies to all
components of the system, i.e. to the central unit, the barrier box, the optics housings, and
the connections.
This device left the factory in good working condition. In order to maintain this status and to
ensure safe operation of the device, observe these instructions and all the specications relevant
to safety.
Observe the information and symbols on the device. Do not remove any information or
symbols from the device. Always keep the information and symbols in a completely legible
state.
WARNING
Loss of explosion protection properties
The test certicate for your explosion-proof device only applies to the original conguration as
well as to the installation and connection according to the switching and piping plans of
Siemens. If one or more components are changed, the explosion protection properties of your
device are abolished.
WARNING
Improper device modications
Risk to personnel, system and environment can result from modications to the device,
particularly in hazardous areas.
• Only carry out modications that are described in the instructions for the device. Failure to
observe this requirement cancels the manufacturer's warranty and the product approvals.
WARNING
Dust layers above 5 mm
Risk of explosion in hazardous areas.
Device may overheat due to dust build up.
• Remove dust layers in excess of 5mm.
LDS 6 & Optics housing CD 6 Compact Operating Instructions
Compact Operating Instructions, 12/2022, A5E03314905-AB 15
To Next Page
Loading...
Need help?
General
