Siemens LDS 6 - Service Instructions

NOTICE
Penetration of moisture into the device
Damage to device.
• Make sure when carrying out cleaning and maintenance work that no moisture penetrates
the inside of the device.
The following safety notes apply to the optics housings.
WARNING
Hot, toxic or corrosive process media
Risk of injury during maintenance work.
When working on the process connection, hot, toxic or corrosive process media could be
released.
• As long as the device is under pressure, do not loosen process connections and do not
remove any parts that are pressurized.
• Before opening or removing the device ensure that process media cannot be released.
WARNING
Maintenance during continued operation in a hazardous area
There is a risk of explosion when carrying out repairs and maintenance on the device in a
hazardous area.
• Isolate the device from power.
- or -
• Ensure that the atmosphere is explosion-free (hot work permit).
CAUTION
Hot surfaces
Risk of burns during maintenance work on parts having surface temperatures exceeding 70 °C
(158°F).
• Take corresponding protective measures, for example by wearing protective gloves.
• After carrying out maintenance, remount touch protection measures.
6.2 Service instructions
The following sections give step-by-step instructions for maintenance and service tasks for the
optics housings.
Service and maintenance
6.2Service instructions
LDS 6 & Optics housing CD 6 Compact Operating Instructions
52 Compact Operating Instructions, 12/2022, A5E03314905-AB