Siemens LDS 6 - Decommissioning

Decommissioning
7
WARNING
Incorrect disassembly
The following risks may result from incorrect disassembly:
- Injury through electric shock
- Risk through emerging media when connected to the process
- Risk of explosion in hazardous area
In order to disassemble correctly, observe the following:
• Before starting work, make sure that you have switched o󹪜 all physical variables such as
pressure, temperature, electricity etc. or that they have a harmless value.
• If the device contains hazardous media, it must be emptied prior to disassembly. Make sure
that no environmentally hazardous media are released.
• Secure the remaining connections so that no damage can result if the process is started
unintentionally.
Devices identi󹪝ed by this symbol may not be disposed of in the municipal
waste disposal services under observance of Directive 2002/96/EC and / or
Directive 2006/66/EC.
Waste electronic and electrical equipment and waste industrial batteries
can be returned to the supplier within the EC or to a locally approved
disposal service. Observe the speci󹪝c regulations valid in your country.
Enclose the bill of lading, return document and decontamination certi󹪝cate in a clear plastic
pouch and attach it 󹪝rmly to the outside of the packaging. Any devices/replacement parts which
are returned without a decontamination declaration will be cleaned at your expense before
further processing. For further details, refer to the operating instructions.
LDS 6 & Optics housing CD 6 Compact Operating Instructions
Compact Operating Instructions, 12/2022, A5E03314905-AB 57