Siemens LDS 6 - Electric Connections; Safety Notes; Unsuitable Cables, Cable Glands And;Or Plugs

Electric connections
4
WARNING
Unsafe connection
Do only use sensor connection cable(s) and hybrid cable(s) delivered by Siemens.
4.1 Safety notes
4.1.1 Unsuitable cables, cable glands and/or plugs
WARNING
Unsuitable cables, cable glands and/or plugs
Risk of explosion in hazardous areas.
• Use only cable glands/plugs that comply with the requirements for the relevant type of
protection.
• Tighten the cable glands in accordance with the torques speci󹪝ed in Technical data
(Page59).
• Close unused cable inlets for the electrical connections.
• When replacing cable glands, only use cable glands of the same type.
• After installation, check that the cables are seated 󹪝rmly.
WARNING
Hazardous contact voltage
Risk of electric shock in case of incorrect connection.
• For the electrical connection speci󹪝cations, refer to the information in Technical data
(Page59).
• At the mounting location of the device observe the applicable directives and laws for
installation of electrical power installations with rated voltages below 1000V.
LDS 6 & Optics housing CD 6 Compact Operating Instructions
Compact Operating Instructions, 12/2022, A5E03314905-AB 31