Siemens LDS 6 - Page 34





6HQVRU
FRQQHFWLRQ
FDEOH
6RFNHW
0XOWLPRGH
6LQJOHPRGH
+\EULGFDEOH
6XSSO\IURPEDUULHUER[
EURZQ>@
JUHHQ>@
JUHHQ>@
EURZQ>@
Figure4-1 Transmitter connections
Figure4-2 Transmitter optics housing
Installing the receiver optics housing
Install the sensor connection cable in the receiver optics housing according to the 󹪝gure
below. Cables are 󹪝xed with gaskets. Always use lubricant on the gaskets before installing,
otherwise they will be very di󹪟cult to remove later.
Connect the multi-mode 󹪝ber to the sensor-board as shown in the 󹪝gure below.
0XOWLPRGH
ILEHU
6HQVRUERDUG
6XSSO\IURPEDUULHUER[
6HQVRU
FRQQHFWLRQ
FDEOH
Figure4-3 Receiver connections
Electric connections
4.2Connecting the LDS 6, optics housing CD 6
LDS 6 & Optics housing CD 6 Compact Operating Instructions
34 Compact Operating Instructions, 12/2022, A5E03314905-AB