Siemens LMV37.400A2 - Page 161

161/213
Building Technologies Basic documentation LMV37.4... CC1P7546en
HVAC Products 26 Parameter level 01.12.2009
F
and
A
and
or
P
Vh
s
mi n %
Bild 1 10/08 07
Press simultaneously
F and A and
or to adjust speed n0 of the load con-
troller.
Example:
20.0
P
Vh
s
mi n %
Bild 1 11/08 07
Release
F and A .
The selected value is adopted.
Example:
20.0
To the next curvepoint
P
Vh
mi n
s%
Bild 112/070 7
Press
.
P9 appears flashing.
Curvepoint for high-fire.
Same procedure as with
P0
Note:
If is pressed first, the display jumps to
90!
To the next curvepoint
Back to the previous
curvepoint
P
Vh
mi n
s%
Bild 113/070 7
Press
.
The display shows
run (identification of start
for setting the curve parameters).
&
Note
When pressing
/
reset
, you are given the choice of proceeding with the ”warm set-
tings” (refer to subsection Warm settings for modulating mode («G mod», «Gp1
mod», «Gp2 mod» and «Lo mod») or, by pressing
ESC
, with the ”cold set-
tings” (refer to subsection Cold settings for «G mod», «Gp1 mod», «Gp2 mod» and
«Lo mod»).