LOGO! manual
EWA 4NEB 712 6006-02
4
2.1 Installing/deinstalling LOGO!
You install LOGO! on a DIN rail as follows:
1. Place LOGO! on the rail.
2. Swivel it. The snap catch on the back of LOGO! must engage.
Depending on the type of DIN rail used, the snapping mechanism may be
a bit stiff. If it is too stiff and LOGO! will not snap on, you can pull the
snap catch down a little, as you do when deinstalling LOGO! as described
below.
You deinstall LOGO! as follows:
1. Insert a screwdriver in the hole shown in the picture at the lower end of
the snap catch, and pull the snap catch downward.
1
2
RC–0049
2. Swivel LOGO! away from the DIN rail.
Installing and wiring LOGO!
To Next Page
Loading...
