Siemens LOGO! 230 RC - Changing a Parameter

69
LOGO! manual
EWA 4NEB 712 6006-02
If no parameter can be set, LOGO! displays the following:
Press ESC
No Param
No parameter can be changed:
ESC returns you to the parametrization
menu
3. Select the desired parameter: or
LOGO! displays a parameter in a separate window.
4. To change a parameter, select it and press the OK key.
4.1.3 Changing a parameter
To change a parameter, you first have to select it (see ”Selecting a parame-
ter”).
You change the value of the parameter in the same way as you entered it
in progamming mode:
1. Move the cursor to the point at which you want to make the change:
or
2. Change the value: or
3. Accept the value: OK
Move: A or "
Change the value: Y or B
Finished: OK
B01:T
T
a
= 00:00m
T = 01:00m
You cannot change the unit of the delay time for the parameter T in para-
meterization mode. This is only possible in programming mode.
Parameterizing LOGO!