LOGO! manual
EWA 4NEB 712 6006-02
62
LOGO! copies the program to the program module/card. While it is doing
this, a ’#’ flashes on the display:
PCLOGO
>LOGOCard
CardLOGO
#
Flashes
When LOGO! has finished copying, it returns to the main menu:
Program..
>PC/Card..
Start
The program is now also on the program module/card. You can remove the
program module/card. Do not forget to replace the cover.
If there is a power failure while LOGO! is copying, you have to copy the
program again once the power has been restored.
3.12.3 Copying a program from the program module/
card to LOGO!
You have a program module/card containing your program. There are 2
ways to copy the program to LOGO!:
S Automatically when LOGO! starts up (power on)
S Via LOGO!’s PC/Card menu
Automatic copying at LOGO! startup
Proceed as follows:
1. Switch LOGO! into programming mode.
2. Switch the power off.
3. Remove the cover from the shaft.
4. Insert the program module/card in the shaft.
5. Switch the power on again.
Programming LOGO!
To Next Page
Loading...
